extreme switch support

[john heasley]

Thu, Aug 02, 2001 at 01:28:04PM -0700, Rizzo, Joe:
> I have upgraded to 2.2b4.  Have not tested with extreme yet, but the
> catalysts can not be polled by rancid.
> I am not sure where to start troubleshooting.  Does cat5rancid have a debug
> switch to see how it is interacting with the cat?
> 
> perl /home/rancid/bin/cat5rancid fesw01.clt-lhr

perl /home/rancid/bin/cat5rancid -dl fesw01.clt-lhr

but, first if you could try clogin -c 'show vers;show vers' switch,
that will tell us how far it is getting.

> fesw01.clt-lhr clogin error: Error: TIMEOUT reached
> missed cmd(s): write term,dir slot0:,dir bootflash:,dir slot1:,show port
> ifindex,show boot,show module,show flash,show version
> End of run not found
> !
> 
> Thanks,
> Joe
> 
> 
>  -----Original Message-----
> From: 	john heasley [mailto:heas at shrubbery.net] 
> Sent:	Thursday, August 02, 2001 2:47 AM
> To:	rancid-discuss at guelah.shrubbery.net
> Subject:	extreme switch support
> 
> appreciate any feedback on following bits to support extreme switch
> collection.
> 
> 	ftp://ftp.shrubbery.net/pub/rancid/rancid-2.2b4.tar.gz
> 
> notes: 
> i do not have a cisco (non-IOS) catalyst with which to test the
> changes to clogin.
> 
> the looking glass bits here are a bit in flux.  if you're using
> the looking glass, you're best off overlaying util/lg/* from 2.1.