[rancid] Re: trying to make sense of a log

[john heasley]

Tue, Sep 19, 2006 at 10:27:45AM -0400, Sam Barnard:
> Does this mean that my rancid user does not have the correct
> permissions?  Can someone sugguest good permissions for the rancid user?
> 
>  
> 
> This is on a Cisco 2948G running IOS 12.0.  I assume it goes in and runs
> all of these commands, but for some reason cannot run them.
> 
>  
> 
> Getting missed routers: round 4.
> 
> <ROUTERIP> clogin error: Error: TIMEOUT reached
> 
> <ROUTERIP>: missed cmd(s): dir /all slavedisk2:,show rsp
> chassis-info,dir /all sec-slot2:,show diag,dir /all disk1:,show gsr
> chassis,dir /all sec-nvram:,dir /all disk2:,dir /all sec-bootflash:,show
> spe version,dir /all slaveslot2:,dir /all disk0:,show install
> active,show bootvar,dir /all slaveslot0:,dir /all sec-slot1:,dir /all
> harddiska:,dir /all slavenvram:,show flash,dir /all sec-disk2:,dir /all
> slavesup-bootflash:,dir /all sec-disk0:,dir /all harddiskb:,show
> variables boot,show boot,dir /all slavedisk1:,show env all,show
> module,show controllers,show diagbus,dir /all slavedisk0:,show idprom
> backplane,dir /all bootflash:,dir /all sec-slot0:,dir /all
> sec-disk1:,write term,show vtp status,dir /all sup-bootflash:,dir /all
> slot2:,dir /all harddisk:,dir /all slot0:,dir /all sup-microcode:,show
> vlan,dir /all slavebootflash:,show controllers cbus,dir /all
> slaveslot1:,dir /all nvram:,show version,show redundancy secondary,show
> running-config,show c7200,dir /all slot1:
> 
> <ROUTERIP>: End of run not found
> 
clogin apparently hung (waiting for data) while collecting rancid's
command output.  Try it manually; take the commands from the bottom part
of the rancid script and run clogin:

	clogin -c 'cmd1;cmd2;...' hostname