[rancid] Re: rancid-2.3.2a6, clogin and HP Switches

[Regnar Bang Lyngsø]

Hi,

for HP equipment use hlogin and not clogin. clogin is for Cisco equipment.

Regards,
-- 
Regnar Bang Lyngsø, Network Administrator
AarhusKarlshamn Denmark A/S
M.P. Bruuns Gade 27, DK-8000 Århus C, Denmark
Email: mailto:regnar.lyngso at aak.com
Phone: +45 87 30 61 65 Mobile: +45 40 45 08 89
Registered office: Aarhus Reg. no: 15672099



feelgravityspull at gmail.com 
Sent by: rancid-discuss-bounces at shrubbery.net


03-08-2007 05:38

To
rancid-discuss at shrubbery.net
cc

Subject
[rancid]  rancid-2.3.2a6, clogin and HP Switches






Just installed the alpha version of rancid and trying to connect to a HP 
ProCurve 5406zl switch.  Using clogin, it works 50% of the time, the other 
50% if hangs on  the " Press any key to continue" login page.

Has anyone seen this before?

Thanks.

fyi: I had to add a "\n" to line 544 on clogin to send the enable command, 
otherwise just "nable" was sent. 
_______________________________________________
Rancid-discuss mailing list
Rancid-discuss at shrubbery.net
http://www.shrubbery.net/mailman/listinfo.cgi/rancid-discuss