[rancid] Re: Rancid -question

[Lance]

Chandrasekaran,

Maybe I am crazy, but I would think you would just need to make a small
adjustment to the code so it will run a show start. If I am right it
would be a simple piece of code.

Maybe even make a copy of RANCIDs script but alter it and change the
show run/write term, to show start. But remember want to remove any of
the old command reference to show run/write term. otherwise you will get
both.

-Lance

> -------- Original Message --------
> Subject: [rancid]  Rancid -question
> From: "Jayaraj, Chandrasekaran"
> <Chandrasekaran.Jayaraj at in.standardchartered.com>
> Date: Wed, June 27, 2007 3:40 am
> To: <rancid-discuss at shrubbery.net>
> 
> Hi All ,
> 
> 
> 
> Rancid does the comparison with the running config on the router . Is
> there a way to make it compare only using the startup configs ?
> 
> 
> 
> warm regards,
> ------------------------------------------------------------------------
> -----
> Chandrasekaran J
> 
> 
> 
> Senior Technical Analyst, Network Center of Excellence,
> 
> 
> 
> 
> 
> This email is confidential. If you are not the addressee tell the
> sender immediately and destroy this email
> without using, sending or storing it. Emails are not secure and may
> suffer errors, viruses, delay,
> interception and amendment. Standard Chartered PLC and subsidiaries
> ("SCGroup") do not accept liability for
> damage caused by this email and may monitor email traffic.<hr>_______________________________________________
> Rancid-discuss mailing list
> Rancid-discuss at shrubbery.net
> http://www.shrubbery.net/mailman/listinfo.cgi/rancid-discuss