[rancid] Re: Issues with cat5

[Ryan DeBerry]

Yes, I am using cat5 as the device type.  I can run clogin and it works
fine.  rancid-run produces the following log.

missed cmd(s): write term all,show port ifindex,show module,dir
sup-microcode:,dir sup-bootflash:,dir bootflash:,dir slot0:,show
version,show flash,show running-config,write term,show boot,dir slot1:,show
inventory raw
: End of run not found


Below is a link to old thread.

http://osdir.com/ml/network.rancid/2008-06/msg00018.html

On Thu, Jan 29, 2009 at 1:05 PM, Michael Stefaniuc <mstefani at redhat.com>wrote:

> Ryan DeBerry wrote:
> > I have seen many posts in the archives with the same issue but I have not
> > seen a resolution.
> Which rancid version are you using? I have submitted patches to fix the
> problem and those were accepted (in a modified) form upstream. I use
> rancid-2.3.2a8 and the only CatOS specific patch I have is to kill the
> bogus "set portcost" config lines.
>
> > clogin works just fine but rancid-run spits out error timeout reached
> Btw. what device type are you using for the CatOS devices: "cisco" or
> "cat5"? "cat5" is the correct type.
>
> bye
>        michael
> --
> Michael Stefaniuc                           Tel.: +49-711-96437-199
> Consulting Communications Engineer          Fax.: +49-711-96437-111
> --------------------------------------------------------------------
> Reg. Adresse: Red Hat GmbH, Otto-Hahn-Strasse 20, 85609 Dornach bei
> Muenchen
> Handelsregister: Amtsgericht Muenchen HRB 153243
> Geschäftsführer: Brendan Lane, Charlie Peters, Michael Cunningham,
>                 Werner Knoblich
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.shrubbery.net/pipermail/rancid-discuss/attachments/20090129/dcd81029/attachment.html