[rancid] Rancid WLC - no command after login

[Ryan West]

Martin,

I assume you're using ciscowlc5?  What you're seeing is the timeout when it tries to run one of the variations of show running-config / show running-config all.

Try adding the -d switch and should see where it times out.

-ryan

-----Original Message-----
From: king1982 at centrum.cz [mailto:king1982 at centrum.cz] 
Sent: Saturday, December 11, 2010 7:59 PM
To: Ryan West; rancid-discuss at shrubbery.net
Subject: RE: [rancid] Rancid WLC - no command after login


Hello Ryan,

WLC SW  version is 5.2.193.0

Martin

______________________________________________________________
> Od: "Ryan West" <rwest at zyedge.com>
> Komu: "king1982 at centrum.cz" <king1982 at centrum.cz>,"rancid-discuss at shrubbery.net" <rancid-discuss at shrubbery.net>
> Datum: 11.12.2010 21:27
> Předmět: RE: [rancid] Rancid WLC - no command after login
>
>Martin,
>
>What version of WLC are you trying to backup?
>
>-ryan
>
>-----Original Message-----
>From: rancid-discuss-bounces at shrubbery.net [mailto:rancid-discuss-bounces at shrubbery.net] On Behalf Of king1982 at centrum.cz
>Sent: Saturday, December 11, 2010 12:30 PM
>To: rancid-discuss at shrubbery.net
>Subject: [rancid] Rancid WLC - no command after login
>
>
>Hello,
>
>I´m trying to set up RANCID to collect my WLC device configurations. 
>
>I placed wlogin, ciscowlc and ciscowlc5 in bin directory of the RANCID, then edit /bin/rancid-fe file: 
>
>'cisco-wlc' => 'ciscowlc',
>'cisco-wlc5' => 'ciscowlc5',
>
>mydevice:ciscowlc:up added to router.db
>
>In log file I found this:
>
>Trying to get all of the configs.
>10.0.0.100: error: Error: TIMEOUT reached
>10.0.0.100: missed cmd(s): show sysinfo,show udi,show run-config commands
>10.0.0.100: End of run not found
>10.0.0.100: wlogin error: Error: TIMEOUT reached
>10.0.0.100: missed cmd(s): show sysinfo,show udi,show run-config commands
>10.0.0.100: End of run not found 
>
>After this result I try to test function of wlogin script: 
>
>wlogin 10.0.0.100 -> "succesfully" log in to device, but I could not use any command as usually (show, ...)
>
>Any suggestions what is wrong?  
>
>Thanks and best regards,
>
>Martin
>_______________________________________________
>Rancid-discuss mailing list
>Rancid-discuss at shrubbery.net
>http://www.shrubbery.net/mailman/listinfo.cgi/rancid-discuss
>