[rancid] Re: Dell Switch Errors

[john heasley]

Wed, Jun 23, 2010 at 12:47:37AM -0400, Willie Bollinger:
>  From what I can see the script does a show version, show vlan, and show 
> running-config and all of these work properly when I telnet into the 
> switch and run them manually.

set NOPIPE=YES and use the rancid script with -d (hopefully the author
maintained that) so that you get a .raw file and log of commands
recognized.

> Corey Chandler wrote:
> > On Jun 22, 2010, at 9:26 PM, Willie Bollinger wrote:
> > 
> >> rancid at staff$ ./dlogin -autoenable -c "show run" -f ../.cloginrc 10.10.111.2
> >> 10.10.111.2
> >> spawn telnet 10.10.111.2
> >> Trying 10.10.111.2...
> >> Connected to 10.10.111.2.
> >> Escape character is '^]'.
> >>
> >>
> >> User Name:rancid
> >> Password:*******
> >>
> >> dsw1-cc#
> >> dsw1-cc#  show run
> >> port jumbo-frame
> >> interface ethernet g48
> >> switchport mode trunk
> >> exit
> >> vlan database
> >>
> >> <snip>
> >>
> >>
> >> Any input would be appreciated
> > 
> > I assume this works when you telnet in and run these commands.  What you might end up doing is running a packet capture via wireshark / tcpdump,  and compare doing it by hand to your clogin command; it may be an improper newline or something simple like that.  
> > 
> 
> -- 
> --------------------------------------------------------------------------
>    Willie Bollinger     | Quantum Internet and Telecommunications
>      410-239-6920       | 2975B Manchester Rd., Manchester, MD  21102
> --------------------------------------------------------------------------
> _______________________________________________
> Rancid-discuss mailing list
> Rancid-discuss at shrubbery.net
> http://www.shrubbery.net/mailman/listinfo.cgi/rancid-discuss