[rancid] Extreme using Cisco Content Type

[David Jones]

On 12/6/2012 1:09 PM, heasley wrote:
> Thu, Dec 06, 2012 at 10:30:26AM -0500, David Jones:
>> Hello,
>>
>> rancid isn't pulling my extreme configs and I think it's because it's
>> trying to use a cisco content type. Here's the output from the ip.new:
>>
>> !RANCID-CONTENT-TYPE: cisco
>>
>> Here's the listing in my router.db:
>>
>> sw1.internal:extreme:up
>>
>> Here's the errors from a rancid -d:
>>
>> sw1.internal: missed cmd(s): show capture,show running-config view
>> full,show spe version,show bootvar,show inventory raw,show shun,more
>> system:running-config,show debug,write term,show vtp status,show
>> vlan,show vlan-switch,show redundancy secondary,show running-config,show
>> c7200
>>
>> Any ideas on how change it from a cisco type to extreme?
>> _______________________________________________
>> Rancid-discuss mailing list
>> Rancid-discuss at shrubbery.net
>> http://www.shrubbery.net/mailman/listinfo.cgi/rancid-discuss
> ugh; i misread that, sorry - i have the flu.
>
> it shouldnt be 'cisco'.  someone must have altered your copy of rancid.
> 'extreme' type should use the xrancid script and the device type there is
> correct.

Ok, I should have used xrancid -d so here's the output of that:

xrancid -d sw1.internal
executing clogin -t 90 -c "show version;show memory;show diag;show 
switch;show slot;show configuration detail;show configuration" sw1.internal
PROMPT MATCH: 16-client-sw-1[:.]\d+ ?#
HIT COMMAND:16-client-sw-1.2 # show version
     In ShowVersion: 16-client-sw-1.2 # show version
HIT COMMAND:16-client-sw-1.3 # show memory
     In ShowMemory: 16-client-sw-1.3 # show memory
HIT COMMAND:16-client-sw-1.4 # show diag
     In ShowDiag: 16-client-sw-1.4 # show diag
HIT COMMAND:16-client-sw-1.5 # show switch
     In ShowSwitch: 16-client-sw-1.5 # show switch
HIT COMMAND:16-client-sw-1.6 # show slot
     In ShowSlot: 16-client-sw-1.6 # show slot
HIT COMMAND:16-client-sw-1.7 # show configuration detail
     In WriteTerm: 16-client-sw-1.7 # show configuration detail
HIT COMMAND:16-client-sw-1.8 #show configuration
     In WriteTerm: 16-client-sw-1.8 #show configuration
172.16.16.55: End of run not found
172.16.16.55: End of run not found
#