[rancid] hp procurve problem - hlogin works - rancid-run fails

[Klavs Klavsen]

I am trying to backup a hp procurve 2520.

using rancid 2.3.6 (I tried updating hlogin to v2.3.8).

When running:
/usr/libexec/rancid/hlogin -c "show version;show flash;show 
system-information;show system information;show module;show stack;write 
term" 10.10.15.96

it seems to work fine. It logs in, runs the commands, and after a few 
seconds (and a lot of output :) - it writes exit etc. and gets out just 
fine.

When I then run rancid-run - I see it has spawned that exact command, 
but there it appearently fails - because the log says:
Trying to get all of the configs.
10.10.15.96: End of run not found
;
=====================================
Getting missed routers: round 1.
10.10.15.96: End of run not found
;
=====================================
Getting missed routers: round 2.
10.10.15.96: End of run not found
;
=====================================
Getting missed routers: round 3.
10.10.15.96: End of run not found
;
=====================================
Getting missed routers: round 4.
10.10.15.96: End of run not found

Any ideas as to what I could do, to try to debug it?

-- 
Regards,
Klavs Klavsen, GSEC - kl at vsen.dk - http://www.vsen.dk - Tlf. 61281200

"Those who do not understand Unix are condemned to reinvent it, poorly."
   --Henry Spencer