[rancid] Setup issue

[Michael T. Voity]

Looks like rancid can't find clogin when in cisco-xr mode -

Which file(s) do i need to mod to make it work?

[rancid at netwatch bin]$ ./rancid -t cisco-xr -d watt-uvm-gw3-200.3.uvm.edu
loadtype: device type cisco-xr
loadtype: found device type cisco-xr in 
/usr/local/rancid/etc/rancid.types.base
executing clogin -t 90 -c"terminal no-timestamp;terminal exec prompt 
no-timestamp;admin show version;admin show install summary;admin show 
license;admin show variables boot;show redundancy secondary;show install 
active;admin show env all;dir /all nvram:;dir /all bootflash:;dir /all 
compactflash:;dir /all compactflasha:;dir /all slot0:;dir /all 
disk0:;dir /all disk0a:;dir /all slot1:;dir /all disk1:;dir /all 
disk1a:;dir /all slot2:;dir /all disk2:;dir /all harddisk:;dir /all 
harddiska:;dir /all harddiskb:;dir /all slavenvram:;dir /all 
slavebootflash:;dir /all slaveslot0:;dir /all slavedisk0:;dir /all 
slaveslot1:;dir /all slavedisk1:;dir /all slaveslot2:;dir /all 
slavedisk2:;dir /all sec-nvram:;dir /all sec-bootflash:;dir /all 
sec-slot0:;dir /all sec-disk0:;dir /all sec-slot1:;dir /all 
sec-disk1:;dir /all sec-slot2:;dir /all sec-disk2:;show 
controllers;admin show diag;admin show inventory raw;show vlan;show 
debug;show rpl maximum;admin show running;show running-config" 
watt-uvm-gw3-200.3.uvm.edu
sh: clogin: command not found
watt-uvm-gw3-200.3.uvm.edu: missed cmd(s): all commands
watt-uvm-gw3-200.3.uvm.edu: End of run not found
watt-uvm-gw3-200.3.uvm.edu: End of run not found

Michael T. Voity
Network Engineer
University of Vermont

On 5/3/14, 10:44 AM, heasley wrote:
> clogin -c "`rancid -C -t cisco-xr`" watt-uvm-gw3-200.3.uvm.edu