[rancid] problem with new Aruba/HP 2920

[heasley]

Sat, Jan 27, 2018 at 10:57:56AM -0500, Doug Hughes:
> got a new HP/Aruba 2920 to replace an old failed 2910al (POE power
> supply failure - very common).. Weird thing is, hlogin doesn't work on
> it. I get an EOF right after trying to send enable and it tries to match
> the many stupid formatting characters that the Aruba folks have tried to
> put into the output.
> 
> I have manually set the switch to vt100 terminal type and reloaded, but
> still it persists and it's loaded with those characters. I can't say
> definitively that they are the issue, but something sure is strange. I
> started looking into it and debugging and noticed all that. Also, clogin
> seems to work (aside from command incompatibility), but hlogin does not
> and gets an EOF prematurely.
> 
> Anybody seen this?

I havent any of these.  Have one that I can poke remotely?  else, collect
debug info from hlogin -d -c ... devicename

> I did just upgraed to rancid3.7 from 3.4.1 to see if that would help,
> and it did not. Same behavior.
> 
> 
> 
> _______________________________________________
> Rancid-discuss mailing list
> Rancid-discuss at shrubbery.net
> http://www.shrubbery.net/mailman/listinfo/rancid-discuss