[rancid] Unable to Conduct Cisco Wireless Controller Backup

[Piegorsch, Weylin William]

When I login as myself and run the "show sysinfo" command, I get the below output.  I notice that rancid (wlogin) gets stuck on the prompt at the end there.  When expect sees the prompt, a <space> would be the appropriate response.  I'm not sure how to disable paging, unfortunately. 

Weylin

(cumm111-wism-aca05) >show sysinfo

Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 8.2.166.0
Bootloader Version............................... 1.0.20
Field Recovery Image Version..................... 7.6.101.1
Firmware Version................................. FPGA 1.7, Env 0.0, USB console 2.2
Build Type....................................... DATA + WPS

System Name...................................... cumm111-wism-aca05
System Location.................................. 111 Cummington St., Room B05
System Contact................................... Network Operations Center
System ObjectID.................................. 1.3.6.1.4.1.9.1.1293
Redundancy Mode.................................. SSO
IP Address....................................... 10.123.18.234
IPv6 Address..................................... ::
Last Reset....................................... Software reset
System Up Time................................... 97 days 17 hrs 26 mins 34 secs
System Timezone Location......................... (GMT -5:00) Eastern Time (US and Canada)
System Stats Realtime Interval................... 5
System Stats Normal Interval..................... 180


--More-- or (q)uit





On 7/26/18, 6:43 PM, "heasley" <heas at shrubbery.net> wrote:

    Thu, Jul 26, 2018 at 09:20:42PM +0000, Piegorsch, Weylin William:
    > I should note that using the NOPIPE=yes thing causes the "controller wlogin error: Error: Connection closed (ssh): controller" message that I show below.  If I omit the NOPIPE environment variable on the CLI, I get the output I showed in the other email, where it hangs in the middle of output.
    > 
    > weylin
    
    i dont see the problem in what you've provided; you'll have to share more
    output with me.
    
    eval `rancid -t cisco-wlc8 -C hostname` &> output