[rancid] Palo Alto (Panorama) configuration

[annie lee]

i tried to grab the configs from the panorama and it's what i wanted :-)
apology, im pretty new to the paloalto and panorama device/setup.

thanks and glad i can backup the palo/panorama configs without any tweaking.

On Thu, Jul 11, 2019 at 9:23 AM annie lee <lsy.annie at gmail.com> wrote:

> Hi John,
>
> Thanks for your reply and apology for the typo on the paloalto type.
> (1.1.1.1;paloalto;up)
> Below are the sample config for one of the firewall configs (removed all
> the ip addresses).
> Basically there are heaps more configs (routing, policy, NAT, virtual
> router and etc...) i can see from the Panorama.
> Not sure its similar to F5 tweak that we need to add the partition to grab
> the full configs.
>
> Rgds
>
> On Thu, Jul 11, 2019 at 7:42 AM john heasley <heas at shrubbery.net> wrote:
>
>> Wed, Jul 10, 2019 at 11:53:42AM +1000, annie lee:
>> > Hi All,
>> >
>> > Another question, just added a new PaloAlto to rancid (3.9) but not much
>> > configurations being backup (not even interfaces addresses)
>> > Anything need to be changed/added to backup the entire configuration ?
>> >
>> > 1.1.1.1;palo-alto;up
>>
>> Please use the built-in type for PAN: paloalto.  if that is still lacking,
>> please be more specific about what commands are missing.  it collects
>>
>> show system info;show chassis inventory;show config running
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.shrubbery.net/pipermail/rancid-discuss/attachments/20190711/219d8851/attachment.html>