[rancid] Unable to pull configuration from Cisco WLC 8.5

Charles Allen charles.allen at zagg.com
Wed Apr 22 21:36:50 UTC 2020


Rancid version: 3.12
Cisco WLC: 8.5.161.0

I cannot successfully pull the configuration from my Cisco WLC.  In every case, it just gives the generic error "End of run not found."  However, if I execute the command to pull configuration via rancid, the .new file looks complete and without issue.  I have tried changing the various commands executed but with no success.  Looking for a smarter person than I to perhaps give some direction or recommendations.

[rancid at xxxx ~]$ NOPIPE=yes rancid -d -t cisco-wlc8 wlc
loadtype: device type cisco-wlc8
loadtype: found device type cisco-wlc8 at /usr/local/rancid/etc/rancid.types.base:351
executing wlogin -t 120 -c"show udi;show sysinfo;show run-config commands" wlc
PROMPT MATCH: \(Cisco Controller\) >
HIT COMMAND:(Cisco Controller) >show udi
    In ShowUdi: (Cisco Controller) >show udi
HIT COMMAND:(Cisco Controller) >show sysinfo
    In ShowSysinfo: (Cisco Controller) >show sysinfo
HIT COMMAND:(Cisco Controller) >show run-config commands
    In ShowConfig: (Cisco Controller) >show run-config commands
wlc    : End of run not found
wlc    : clean_run is false
!--WLC End Config Data--!
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.shrubbery.net/pipermail/rancid-discuss/attachments/20200422/f64d039e/attachment.htm>


More information about the Rancid-discuss mailing list