[tac_plus] Re: Configuring tac_plus for Foundry BI-RX-16

[Schmidt, Daniel]

I never had a need to set levels at a per device basis, as the levels
don't provide much control.  But, I did have a need to set command
access on per device basis which can accomplish the same thing.  See
www.tacacs.org.

-----Original Message-----
From: tac_plus-bounces at shrubbery.net
[mailto:tac_plus-bounces at shrubbery.net] On Behalf Of Jeff Wieland
Sent: Wednesday, September 02, 2009 12:26 PM
To: tac_plus at shrubbery.net
Subject: [tac_plus] Configuring tac_plus for Foundry BI-RX-16

Our engineer reports that these switches use the privilege level
backwards from Cisco -- 0 is for enable/superuser, 15 is the
default for user logins.  So, I'm thinking that I need a way to
specify the priv-lvl on a per-device basis, or on an "service"
basis assuming that I can figure out what service to use.  Has
anybody got one of these working?
-- 
           Jeff Wieland            |         Purdue University
    Network Systems Administrator  |        ITN&S Data Networks
        Voice: (765)496-8234       |        501 Harrison Street
         FAX: (765)494-6620        |   West Lafayette, IN 47907-2025

_______________________________________________
tac_plus mailing list
tac_plus at shrubbery.net
http://www.shrubbery.net/mailman/listinfo.cgi/tac_plus