[tac_plus] Re: Authorization script and before authorization

[Tourneur Henry-Nicolas]

On Wednesday 12 May 2010 06:57:35 john heasley wrote:
> Wed, May 12, 2010 at 06:34:24AM +0200, Kiss Gabor (Bitman):
> > > > > Basically, I need 2 args, the ip of the device where we are trying
> > > > > to execute the command ($ip I guess) and the command itself. But I
> > > > > don't
> > >
> > > 2? I go in enable and then configure mode.
> > > 3? I enter the command no interface GigabitEthernet0/1.114 (for
> > > example) 4? When I enter the previous command, I would like to run an
> > > authorization script on the no interface command. The script will be on
> > > the same host than
> >
> > Oh I see. :-) "The command to be authorized".
> > I guessed you mean a command to execute on TACACS+ server.
> >
> > > Where $ip should be (I guess) the IP address of the Cisco router.
> > > With that sample, I'm still missing the whole command as an argument of
> > > my script (/usr/local/bin/script don't know what to check).
> > >
> > > Do you know how to pass the command as an argument to the script ?
> >
> > Actually I don't know such a possibility.
> > However I think you are able to modify the source code quite easily
> > in order to get a new dollar variable.
> 
> i think theyre passed on stdin as AVPs arg1...argN.
> 
> > Regards
> >
> > Gabor
> 

Is there any available doc/example on how to use those AVPs arg1...argN ?

Thanks for all your replies :)