[rancid] Re: Cisco 6500 with IOS-Like os

[Paul Bliss]

I had:
"es2:cisco:up"

I had tried "es2:cat5:up" previously without success, but I suppose i had
mitigating issues because I just did a /bin/rancid-run -r es2 and it
seemed to work just fine!
Thanks so much guys!

-Paul

On Wed, 12 Apr 2006, Russell Harrison wrote:

> For CatOS devices, make sure the device type in your router.db is
> "cat5".  For example,
>
> es2:cat5:up
>
> -RH
>
> On 4/12/06, Paul Bliss <pbliss at mechno.com> wrote:
> > Hello group,
> >  I'm sorry if this has been done to death, but I've got a Cisco catalyst
> > 6500 that I'm having trouble getting the configs backed up on.
> > It's status is staying "new router" and the logs indicate: "es2: End of
> > run not found"
> >
> > I understand that the prompt has to look a certain way for RANCID to
> > understand where the config starts and ends, but what I don't understand
> > is how I need to change my c
> > config to get the correct prompt convention going.
> >
> > Below is how the "show run" outputs now.
> >
> >
> > es2> (enable) sh run
> > This command shows non-default configurations only.
> > Use 'show config all' to show both default and non-default configurations.
> > .................
> > ............................
> > .
> > .
> > .
> > .
> > #module 15 empty
> > !
> > #module 16 empty
> > end
> > es2> (enable)
> >
> >
> > Thanks so much!
> > Paul
> >
> > _______________________________________________
> > Rancid-discuss mailing list
> > Rancid-discuss at shrubbery.net
> > http://www.shrubbery.net/mailman/listinfo.cgi/rancid-discuss
> >
>