[rancid] Re: Cisco WLC

[Sam Munzani]

Ryan West wrote:
> David,
>
>    
>> -----Original Message-----
>> From: David Mantock [mailto:david.mantock at gmx.ch]
>> Sent: Wednesday, February 17, 2010 7:49 AM
>> Subject: Cisco WLC
>>
>> Hello All,
>>
>> I have seen on this board scripts to backup cisco WLC devices. What is
>> the suggested procedure to include:
>>
>> wlogin and ciscowlc scripts in standard rancid.
>>
>> Do you have to update the normal rancid script to call these?
>>
>> How do you configure router.db file e.g
>>
>> mydevice:ciscowlc:up
>>      
> Yup, unless it's a version 5, in which case it would be ciscowlc5.  The only difference is that 'show running-config' (version 4) has been moved to 'show run-config commands' in version 5.  Pretty sure with basic version check, the proper command file could be parsed.
>    
Did you check "show run" on both platforms? It should work on both since 
cisco allows short commands as long as its uniq.

Thanks,
Sam
>    
>> Any inputs are much appreciated.
>>
>> As Jeremy suggested it would be nice if there was a little Howto as
>> some people already have this working.
>>
>>      
> Place wlogin, ciscowlc, and ciscowlc5 in your bin directory of the RANCID install.  Then add the following two lines to your $PREFIX/bin/rancid-fe file:
>
>      'cisco-wlc'         =>  'ciscowlc',
>      'cisco-wlc5'         =>  'ciscowlc5',
>
> That should be it.
>
> -ryan
>
> _______________________________________________
> Rancid-discuss mailing list
> Rancid-discuss at shrubbery.net
> http://www.shrubbery.net/mailman/listinfo.cgi/rancid-discuss
>
>