[rancid] fortinet problem

[Fürtbauer Wolfgang]

Dear John,

Output of nlogin is:

rancid at aohmonitoring01:~> nlogin <fortinet>
<fortinet>
spawn ssh -c 3des -x -l monitoring <fortinet>
monitoring@<fortinet>'s password:
FGT50A3906508751 #
FGT50A3906508751 # Timeout
exit
Connection to <fortinet> closed.
rancid at aohmonitoring01:~>


If seen a lot of discussion about fortinet and rancid and it seams
There are some patches around - but I was not able to find them :(
Probably one of the fellow collegues can guide me?!

Thanks in advance
Wolfgang 


Wolfgang Fürtbauer
Leitung IT

ASAMER Holding AG
Unterthalham Strasse 2
4694 Ohlsdorf
AUSTRIA
tel +43 50 799 - 2500
fax +43 7612 799 - 9526
mobile  +43 664 8332326
w.fuertbauer at asamer.at
www.asamer.at


This message is confidential. It may not be disclosed to, or used by, anyone other than the addressee. If you receive this
message by mistake, please advise the sender.



-----Ursprüngliche Nachricht-----
Von: john heasley [mailto:heas at shrubbery.net] 
Gesendet: Donnerstag, 30. September 2010 21:15
An: Fürtbauer Wolfgang
Betreff: Re: [rancid] fortinet problem

Thu, Sep 30, 2010 at 04:36:35PM +0200, F?rtbauer Wolfgang:
> Dear collegues,
>  
> running rancid 2.3.4 with HP and CISCO without problems.
> Now I want to add my fortigate devices - but it does not work :(
>  
> .cloginrc:
> add user <fortinet> <a_user>
> add password <fortinet> <a_password>
> add method <fortinet> ssh
> add autoenable <fortinet> 0
>  
> router.db:
> <fortinet>:fortigate:up
>  
> with rancid-run it hangs and I get the following errormessages:
>  
> Trying to get all of the configs.
> <fortinet>: missed cmd(s): show,get system status
> 0: found end
> <fortinet>: End of run not found

i am not familiar with fortigate.  but, you probably want to start by verifying that nlogin works for the device, as suggested in the RANCID FAQ section 3.