[rancid] Malfunction between rancid and HP 2910.

[Vincent LOUPIEN]

Hi all,

We replaced the old good HP Procurve 2650 by more resent HP Procurve 2910 and since, rancid refuse to backup theirs configurations, while this was going very well with 2650. All the parameters seem correct (telnet / ssh, password ...) and are becoming the same as for 2650. 

Debugging using clogin works very well but with the use of rancid-run in crond, it creates problems without messages/errors.
I tried also use Foundry group in place of HP to operate but with no success. Same rancid backup Cisco switchs/routers with no problem.

Do you have an idea where this problem come from or "search paths".

Debian version of rancid = 2.3.2~a8-4
HP Procurve 2910 firmware = W.14.49.

Regards,

-- 
____________________________________________________________ 
Vincent LOUPIEN - Direction des Systemes d'Information 
Batiment Langues, Nouvelles Technologies - Bureau 37
Universite Pierre Mendes France - Domaine Universitaire 
79, rue des Universites - BP 47 - F-38040 Grenoble Cedex 9 
Tel : (+33).04.76.82.57.58 - Fax : (+33).04.76.82.83.13 
____________________________________________________________