[rancid] blank log files on initial install
scott.granados at gmail.com
Thu May 7 12:24:22 UTC 2015
Wow I saw no mention of that in the doc. I will give this a try. I think I may have a “ missing in my config as well after coming back to this with some sleep this morning.
I will give both a try and thank you much for the pointer.
On May 6, 2015, at 9:08 PM, Kenneth <lind108 at hotmail.com> wrote:
> Check your router.db file and ensure you're using the correct delimiter. I had the same problem when I first upgraded to 3.1 and it took me far too long to find that you need to use a semicolon instead of a colon (a little RTFM and some hair pulling helped) and I experienced the same problem you describe.
> Example router.db entry for 3.1+ (to allow for IPv6 addressing):
> On May 6, 2015 20:57, Scott Granados <scott.granados at gmail.com> wrote:
> Hi, this may be a very n00by question but googling hasn’t helped so I thought I’d ask here. I just installed a fresh copy of rancid-3.2. Admittedly my previous attempt has been using yum or apt-get to install rancid 2.3.6 but this time I downloaded the source and compiled. There were no errors during compilation.
> When I run rancid-run the process exits very quickly and the generated log files for each group show a start and end with no text in-between. However, if I run the clog in command with a router name it logs in fine and drops me in to the network element. What should I check to diagnose the lack of configs being pulled and the totally empty logs other than the words start and end. Any pointers would be most appreciated.
> Thank you
> Rancid-discuss mailing list
> Rancid-discuss at shrubbery.net
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Rancid-discuss