[rancid] Palo Alto issue

[Daren McGill]

I just upgraded to 3.2 as Palo Alto was now integrated ran into the following issue. If I run the command in rancid it goes to run the right command but comes back with nothing. However if I run the command for panlogin direct it works great. See output below.

[rancid at lei-tac-prd-254 ~]$ export NOPIPE=YES; rancid -d -t paloalto crp01-pan02
loadtype: device type paloalto
loadtype: found device type paloalto in /usr/local/rancid/etc/rancid.types.base
executing panlogin -t 90 -c"set cli scripting-mode on;set cli pager off;show system info;show config running" crp01-pan02
crp01-pan02: missed cmd(s): all commands
crp01-pan02: End of run not found
crp01-pan02: End of run not found


[rancid at lei-tac-prd-254 ~]$ panlogin -t 90 -c"set cli scripting-mode on;set cli pager off;show system info;show config running" crp01-pan02
crp01-pan02
spawn ssh -c 3des -x -l svc-rancid crp01-pan02
Password:
Last login: Wed Sep  9 15:59:34 2015 from 10.2.10.254
Welcome svc-rancid.

svc-rancid at CRP01-PAN02(active)>
svc-rancid at CRP01-PAN02(active)>
svc-rancid at CRP01-PAN02(active)> set cli scripting-mode on
svc-rancid at CRP01-PAN02(active)> set cli pager off
svc-rancid at CRP01-PAN02(active)> show system info

hostname: CRP01-PAN02

The config scrolls after this with no issues.

Thanks,
Daren
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.shrubbery.net/pipermail/rancid-discuss/attachments/20150909/d48894b1/attachment.html>