[rancid] Cisco commands in 3.6.2

[heasley]

Wed, Jun 28, 2017 at 08:30:32PM +0000, Piegorsch, Weylin William:
> Does this help?  I just ran this on an ASA I currently have in Rancid (v3.4).
> weylin
> 
> ASA5545-X-version9.4(4)5/pri/act# sh inventory ?
> 
>   <0-3>  Inventory slot number
>   |      Output modifiers
>   <cr>
> ASA5545-X-version9.4(4)5/pri/act# sh inventory

yes; it doesnt support the raw keyword.  What does the o/p look like (w/o a
slot speicfied)?

> -----Original Message-----
> From: heasley <heas at shrubbery.net>
> Date: Wednesday, June 28, 2017 at 13:32
> To: Craig Hopkins <c.o.hopkins at gmail.com>
> Cc: <rancid-discuss at shrubbery.net>
> Subject: Re: [rancid] Cisco commands in 3.6.2
> 
>     Wed, Jun 28, 2017 at 10:10:23AM +0100, Craig Hopkins:
>     > Hi,
>     > 
>     > rancid is happily backing up my ASAs and switches, but in rancid.types.base
>     > I can see
>     > 
>     > cisco;command;ios::ShowInventory;show inventory raw
>     > 
>     > How do I get rancid to run this command on a Cisco? It isn't currently. It
>     > looks like it's just doing show version, show flash and show running.
>     
>     it is run; but if the command is not supported by the device or is different
>     on the ASA (because cisco is incapable of consistency between platforms) and
>     therefore is "ambiguous", that failure will be ignored by rancid.  if you
>     know what the correct command is for the ASA, lmk.
>     
>     
>     
>