Index |
Auto-Negotiation, 1
Boot Process on the Network, 1
Correcting Errors in Negotiating, 1
External Transceiver, 1
Internal (Local) Transceiver, 1
Auto-Negotiation Protocol, 1
from network, 1
Booting From the Network, 1
nvedit , 1
nvstore , 1
prtconf , 1
setenv , 1
show-devs , 1
show-nets , 1
Configuring the Hostname File, 1
Media Independent Interface, 1
RJ-45, 1
Defining an Additional Delay Before Transmitting a Packet Using lance_mode and ipg0 , 1
Defining the Number of Back-to-Back Packets to Transmit, 1
Data Link Provider Interface, 1
/etc/system , 1
Driver Parameter Values and Definitions, 1
/etc/system file, 1
example, 1
Fast Ethernet Parallel Port SCSI, 1
SBus, 1
/etc/hostname. hme num , 1
/etc/hosts, 1
/etc/path_to_inst, 1
Hardware Overview, 1
example, 1
Identifying Device Instances, 1
Installing the Driver Software, 1
Inter-Packet Gap Parameters, 1
Link partner, 1
local-mac-address Property, 1
local-mac-address? variable, 1
Media Access Control, 1
MAC address, 1
ndd utility, 1
forcing between 10 and 100 Mbps, 1
Non-Interactive and Interactive Modes, 1
Operating Speeds and Modes, 1
Operational Mode Parameters, 1
Operational Mode Priorities, 1
Optional Post-Installation Procedures, 1
Parameter Setting Options, 1
100T4_cap , 1
adv_100T4_cap , 1
Defining the Current Status, 1
instance , 1
lp)100T4_cap , 1
lp_100hdx_cap , 1
transceiver_inuse , 1
transciever_inuse , 1
use_int_xcvr , 1
path_to_inst output, 1
Name, Parent, Unit Address, 1
PCI-bus, 1
Operational Mode Priorities, 1
Reporting the Link Partner Capabilities, 1
Reporting Transceiver Capabilities, 1
Selecting the Internal or External Transceiver, 1
Setting Auto-Negotiation Mode, 1
Setting Driver Parameters, 1
Setting Driver Parameters for PCI-Bus hme Interfaces Using hme.conf , 1
Setting Forced Mode, 1
Setting Parameters in the /etc/system File, 1
Setting Parameters Using ndd , 1
Setting Parameters Using the hme.conf File, 1
show-devs output, 1
show-nets output, 1
installation, 1
driver parameters, 1
Supported Hardware, 1
To Boot From the Network, 1
To Configure the Hostname File, 1
To Force Network Speed Between 10 Mbps and 100 Mbps, 1
To Select One Local Transceiver Capability and Setting Forced Mode, 1
To Set Driver Parameters With PCI-Bus Based Systems, 1
To Set ipg1 to 20 and ipg2 to 10 in S Bus Slot 0xe, 1
To Set the ipg1 to 10 and ipg2 to 5 When Rebooting, 1
To Set the Mode to Auto-Negotiation, 1
To Specify the Device Instance for the ndd Utility, 1
Transceivers available in Sun adapters, 1
Using the ndd Utility in Interactive Mode, 1
Using the ndd Utility in Non-Interactive Mode, 1
Copyright © 2002, Sun Microsystems, Inc. All rights reserved.