Ultra[tm] 60 Workstation: Repair Procedures

This section provides the most common repair procedures for the Ultra 60 workstation. Many of the written procedures below are links to the Ultra 60 Service Manual (805-1709).

Component	Remove	Install	Tips
Audio Card	X	X
CD-ROM Drive	X	X
CPU Module	X	X	The current diagnostic procedure to identify the faulty CPU module from CPU Ecache parity errors is flawed (FIN I0570-3). UltraSPARC-IIs CPU Module Installation Guide Special Considerations for Systems With 450 MHz CPU Modules
Disk Drive	X	X	18.2GB and 36GB IBM disk drives may be susceptible to early life failures problem (FIN I0724-2). 18GB and 36GB IBM disk drives experiencing high failure rate in high humidity and high temperature environments (FCO A0182-1). Ultra[TM] 60: Error:Server unable to boot with error message: MSGREJ not expected (SRDB 49494).
Floppy Drive	X	X
Memory	X	X
NVRAM/TOD Module	X	X
PCI Card	X	X	SunPCi II and SunPCi IIpro cards may not respond after rapid/successive power cycling (FCO A0186-1). A host system using the 375-0040-01 or -02 FC100/P FC-AL PCI card to attach to FC-AL storage (StorEdge A5x00 and A3500) may experience loop errors, which may affect data access to that storage (FCO A0164-1). Systems based on the PSYCHO chipset panic with a PCI bus error (SRDB 40602).
PCI Fan Assembly	X	X	A noise reduction kit (X2087A ) is available to reduce acoustic noise of system (FIN I0538-1).
Power Supply	X	X
Removable Media Assembly (RMA)	X	X
System Board	X	X	Ultra 60 systems shipped out of Sun UK may experience crystal reliability issues which results in mutliple failure types (FCO A0158-1).
Tape Drive	X	X
UPA Graphics Card	X	X	SunBlade 1000/2000 and Ultra 60/80 systems may exhibit a blank screen upon boot up with an XVR-1000 Graphics Accelerator installed (FCO A0200-1).